In most trawl fisheries, drag forces tend to close the meshes in large areas of diamond mesh codends, negatively affecting their selective potential. In the Barents Sea deep-water shrimp (Pandalus borealis) trawl fishery, selectivity is based on a sorting grid followed by a diamond mesh codend. However, the retention of juvenile fish as well as undersized shrimp is still a problem. In this study, ...

The Nordmøre grid is the principle bycatch mitigation device in many shrimp trawl fisheries. However, in several of these fisheries, bycatch is a problem because small sized fish can pass through the grid and enter the codend together with the targeted shrimp. One such fishery is the Northeast Atlantic deep-water shrimp (<i>Pandalus borealis</i>) fishery, where the use of a Nordmøre grid is mandatory. ...

The catch efficiency of two types of groundgear—a conventional rockhopper and a new type of groundgear called the semicircular spreading gear (SCSG)—was investigated through experimental fishing for Haddock Melanogrammus aeglefinus conducted in the Barents Sea. A retainer bag was attached behind the footrope of the trawl, and the number of fish that were overrun by the trawl was compared with the ...

The Nordmøre grid is widely used in shrimp trawls to reduce the bycatch of fish species. However, small-sized fish species and juveniles still pass through the grid and enter the codend, along with the targeted shrimp. This bycatch of small fish has a negative impact on the ecosystem due to increased fish mortality, and leads to additional sorting work onboard. Some small-sized fish that enter the ...

Fuel consumption and environmental concerns have led bottom trawlers fishing for cod (Gadus morhua) in the Barents Sea to use semi-pelagic doors. However, this change may affect fish herding and consequently the catch efficiency of the gear. In this study we compared the catch efficiency of two different setups where the sweep length with bottom contact was different. This setup also enabled us to ...

The present study reports results of a small-scale preliminary experiment to evaluate whether lifting trawl doors and sweeps from the seabed can lead to a reduction of by-catch in the Northeast Arctic shrimp trawl fishery. We carried out a catch comparison and catch ratio analysis between two gear configurations: one with trawl doors and sweeps on the seabed (traditional rigging) and the other with ...

The high abundances of Northeast Arctic cod (Gadus morhua) in the Barents Sea have led to the development of a new fishing tactic called buffer towing. On factory trawlers, the trawl is deployed immediately after taking the catch onboard, a tactic used to ensure a continuous supply of fish is being processed. If the desired amount of fish is caught before the catch from the previous haul has been ...

The aim of this study was to provide practitioners working with trawl selectivity with general and easily understandable guidelines regarding the fish sampling effort necessary during sea trials. In particular, we focused on how many fish would need to be caught and length measured in a trawl haul in order to assess the selectivity parameters of the trawl at a designated uncertainty level. We also ...

In the deep sea trawl fishery targeting shrimp (Pandalus borealis) and other cold-water shrimp species, fishers often use a Nordmöre sorting grid ahead of a small mesh codend to avoid bycatch. However, small fish can pass through the grid and are subsequently retained in the codend. This makes shrimp size selection complex and the size-dependent curve for both the shrimp and the bycatch species often ...

The escape of small smolt through farm cage netting is a major challenge faced by the Norwegian salmon farming industry. Escape can occur when the smolt placed in the cages are smaller than the size estimated by the farmers. Furthermore, one may assume wrong mesh-properties as the cage netting change shape and/or state from stiff (mesh bars with tension) to slack (mesh bars without tension) due to ...